Find answers to your questions about Arduino or help others by answering their Arduino questions.
Here's what I think happens and how long it takes (FIXME means I don't know). I'd like to end up with solid max times for everything if possible.Power-on, input...
Asked on 11/30/2020 by Britton Kerin
1 answerwhen I connect VCC pin to the 5V and GND to the GND on the Arduino MEGA, then sometimes the display glows and sometimes it doesn't. It kinda looks like...
Asked on 11/29/2020 by Elayer213
0 answerFirst off, I'm very new to Arduinos and electronics in general, so feel free to explain like I'm 5. As a bit of background to this question, the project is...
Asked on 11/10/2020 by Don
1 answerI have three libraries that I've written and I'm trying to use. They're stored as followsDocuments├── Some/Path/To/Folder│ └── firmware.ino└── Arduino └── libraries ...
Asked on 11/06/2020 by omar_hussein
1 answerRunning a DC motor(6.5A max input), motor driver (MD10C 7Amp peak output), and Arduino Mega. I am stabilizing an object with an accelerometer as my sensor. I switched to longer...
Asked on 10/28/2020 by Thunder Dornhofer
2 answerI started one project where i need 4 servos to control 4 grabbers jaws. i use STM32F103C8T6 with arduino IDE for programming it. The motor TZT Micro Servo 9g SG...
Asked on 10/25/2020
0 answerSo I have a program that measures temperature and humidity over time. Here isthe code I use:#include <SD.h>#include <SPI.h>#include <DHT.h>#include <Wire.h> #include "RTClib.h"#define DHTPIN 2 #define DHTTYPE 22const int...
Asked on 10/22/2020 by imRobert7
1 answerI am working on a project which involves counting the drops falling in a drip chamber of a IV fluid gravity based therapy bottle(saline bottle).I am using IR trans-receiver at...
Asked on 10/20/2020 by CHETAN NIRADWAR
1 answerI am using multiple temperature sensors using I2C. Some of the sensors are connected via TCA9548 multiplexer. When I run the sketch it runs fine for a few minutes but...
Asked on 10/06/2020 by Zaffresky
0 answerI would like to exit a particular loop if the state of an input changes from LOW to HIGH. This is the current loop:void brakeFade() {pixels.clear();pixels.setBrightness(255);pixels.fill(16711680, 0, 0);for(int i=255;...
Asked on 09/15/2020 by JabawokJayUK
1 answerGet help from others!
Recent Answers
Recent Questions
© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP