I’m using Microwave Solutions MDU1720 datasheet with recommendation that The length of leads connecting the MDU to the signal processing circuitry must be minimised, to reduce pick up of electromagnetic interference. A maximum lead length of 1.5cm is recommended and screened leads are preferred. Due to other prototype constraints, however, I’m stuck with 15cm long 22gauge unshielded hookup wire for the +5V and GND leads. Would it be likely enough to just twist these leads together and run perpendicularly away from the pcb?
1 Asked on August 29, 2020 by hos
4 Asked on August 27, 2020 by metrryboros
1 Asked on August 22, 2020 by jess
1 Asked on August 19, 2020 by vincent-diallo-nort
4 Asked on August 10, 2020 by d0bz
2 Asked on August 9, 2020 by marcos
1 Asked on July 25, 2020 by riccardo-minati
2 Asked on July 24, 2020 by ross
4 Asked on July 23, 2020 by nachonachoman
Get help from others!