heat sink solution for light source around 1000°C

Electrical Engineering Asked by Ross on July 24, 2020

I’m going to use a infrared light source IR12k which can reach 975°C for my design. However, I’m not sure whether I can solder this light source with cable whose other end is soldered with power board. This is because the temperature of the light source is obviously above the melting point of the solder tin. My concern is that the solder joint may get loose or melted when the source light is working. If so, is there any safe heat sinking solution that can avoid the melt of solder tin in this situation?

2 Answers

The coiled filament operates at 900°C when powered with 10 watts

Only the filament gets hot. Which is wound around a ceramic rod suspensed on two steel poles. Before this 10 Watt conducts down to the solder joints of your connector it needs to heat the metal and ceramic base which you can inserted in a heatsink.

I suspect you can't solder the steel pins, so a solder joint failure is impossible.

Also it's 80 GBP, you can ask the vendor for that.

Answered by Jeroen3 on July 24, 2020

They claim it can be mounted on a PCB. Easy enough to test it on a bit of perf board, though the manufacturer should be able to advise. Definitely put the reflector shield in place.

I suggest using a couple of Mill-Max socket pins.

It's only 11W, so aside from IR radiation heating the PCB, it's not necessarily much worse than an 11W power transistor.

Note: If/when you get a definitive answer from the manufacturer or supplier, you should make your own answer and choose it.

Answered by Spehro Pefhany on July 24, 2020

Add your own answers!

Related Questions

LED driver circuit interfering with 555 timer?

1  Asked on December 10, 2021 by m-v


Placement of Vias under thermal pads

2  Asked on December 10, 2021 by karthik-singhania


STM32 Output current capabilities

2  Asked on December 10, 2021


Thermopile temperature sensor

1  Asked on December 10, 2021 by sumy-poulose


Measuring back EMF induced current with multimeter

3  Asked on December 10, 2021 by rabih-sarieddine


Gate driver Isolation

1  Asked on December 10, 2021 by sm32


Which remote communcation type should I use?

2  Asked on December 8, 2021 by enes-can-etiner


DMX Control – 50W COB LED

2  Asked on December 8, 2021 by basethree


Zero Crossing Detector Circuit

3  Asked on December 8, 2021 by saman-wajid


Ask a Question

Get help from others!

© 2023 All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP