Extruding two edges in solidworks?

Engineering Asked by Gerardo González on March 27, 2021

I need to make this structure:

from this other:

but I don’t figure how, I tried to "Convert Entities", but doesn’t work. Can you help me?

One Answer

See below - I don't know what about convert entities is not working for you - it's fine for this application.

It's worth noting, that this kind of referencing to edges is not typically recommended - better to make both the main body and the raised edges from a single master sketch - but there's not enough information in your question to recommend a better modelling process.

Answered by Jonathan R Swift on March 27, 2021

Extruding two edges in solidworks?

One Answer

Add your own answers!

Related Questions

Transfer Function

Calculate the temperature stability of wavelength demultiplexer

Transfer function into block diagram and matrix form

Time-rate of change of P and T in a pressurized rigid volume with a hole in it

Thread adapters larger than 1/2″

Fixed end moments

Assumption of specific enthalpy

Reacting Propeller Torque?

Questions regarding Cornering Stiffness for RC Car

What’s the difference between Strain tensor and deformation gradient tensor?

Gear Design – Hunting tooth

Calculating Minimum Pipe Pressure Requirement for an Irrigation System

Question on fluid flow measurement uncertainty

What is the name of a half wall with posts on top that divides a space into two?

Is transverse synonym of lateral?

Using a thermos flask as a vacuum chamber

How to add comments to solidworks variable file?

Help in Inverse Laplace Transform in Circuit Analysis

Why isn’t von Mises criterion valid when compressive and tensile yield stresses differ?

Hand thread taps for stainless steel

Ask a Question