TransWikia.com

How to machine a metal shaft that cannot be turned on a lathe

Engineering Asked by user11449 on February 19, 2021

On a lawn mower there is a non-removeable metal shaft on which a pulley stack sits. The problem is that worn out bushings caused the shaft to wear in two places and this is causing the drive belt for the blades to be out of alignment and thus throw the belts. My question is, how can I engineer a solution to either shim up or machine the shaft on the deck when turning it on a lathe is not an option?

One Answer

This could be done several ways that cost more than a new deck would.

The best solution I can think of would be to grind off the existing shaft, if it was pressed in you can grind / press out the remaining shaft then weld across the hole (not easy but possible). Then grind the weld flat and drill a new hole. To make it easier you could weld on a .25" or .125" plate instead of filling in and re-drilling the hole.

I would probably use a bolted shaft instead of a pressed in one so you can replace it in the future; a good shoulder bolt may work.

Answered by Gwydionforge on February 19, 2021

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP