TransWikia.com

How can I repair rotten siding around my hose spigot?

Home Improvement Asked on May 19, 2021

I was getting ready to repaint a siding board with peeling paint, when I realized there was quite a bit of rotten wood around the hose spigot that goes through the plank. Below are some pictures from after I cleared away most of the soft wood.

Can I repair this without replacing the board, or do I need to hire someone to replace the board? I’ve repaired some small areas of rot in other areas with wood hardener and epoxy putty, but those repairs didn’t go through the board and I’m not sure if it would work to screw the spigot into the epoxy. Replacement won’t be so simple since it’s a frost-free spigot and someone would need to cut an access panel in our finished basement to remove it.

siding board with spigot

spigot above

It’s not possible to see in the picture below, but the rot extends upwards behind the board for about a half-inch.

spigot left

spigot right

One Answer

enter image description here

As a rule I don't like using short pieces of siding mid run. But you may need to run pieces shorter than 4' to do this repair. Make sure your final cuts do not line up with another joint above or below the next course. Plan your cuts from top to bottom, since cutting an upper piece of siding first, may make it easier to cut the next piece down. Also locate the new joints over studs.

When adding the new siding, use material behind the joints to divert the water that will come in during foul weather. There are materials available that are specific for this purpose, but I have used aluminum, sheet plastic, or tar paper to use as a "slip" behind joints.

Answered by Jack on May 19, 2021

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP