TransWikia.com

radon mitigation fan running, but u-tube manometer shows no pressure differential

Home Improvement Asked by twd000 on March 19, 2021

We moved into this house in New Hampshire a year ago. Tons of radon off-gassing in this area due to granite rock substrate . Home inspection showed that the mitigation system was functioning properly, long-term test results below 2 pc/L. Recently I noticed that the manometer was showing equal readings on both sides of the u-tube. I don’t recall what the level was during the home inspection. There are no marks I can see on the gage. When I turn off the breaker powering the fan, there is no change on the manometer. The fan is running; I climbed up and stuck my face it the exhaust; it smells wet and musty like basement air. It inflated a plastic shopping bag immediately. The sump pit looks to be well-sealed with silicone caulk. But I also see a 3″ diameter hole through the concrete slab that is covered with a thin piece of cardboard. I can hear it whistling, and when I put my hand in the hole I can feel suction. Is there anyway for me to gain confidence in this radon mitigation system without hiring a contractor?

enter image description here

enter image description here

3 Answers

U tubes are quite simple devices. Make sure the tube connection is not plugged. The hole may be the problem, try plugging it then if the pressure Increases you have found the problem if there are no restrictions for air to enter the pressure will be the same on both sides and no difference in the reading.

Answered by Ed Beal on March 19, 2021

Our u-tube shows a 2" WC. IMO, the hole is the problem: the pump is sucking air from the basement, making both sides of the tube at the same (basement) pressure. Hence, 0 pressure difference. This will obviously reduce the suction from the subsoil; at the same time, it will be pulling radon-contaminated air from the basement. I have no idea what the net effect would be.

You could get a continuous radon monitor. (Amazon, $130) Not cheap, but I find ours very reassuring.

FYI, a couple of things, from experience with our system. (It doesn't seem like these apply to your problem, but just in case.)

  1. We've had the outlet ice up in winter. (Moist air from sump, cold pipe.) When this happened, we showed 0 pressure.
  2. We've had problems in summer, where a water bubble developed in the u-tube. This affected the reading, but I don't remember how much. At the time, we were drawing outside air into the basement, and getting a lot of condensation. So, warm air, u-tube in contact with the cold pipe. We now keep the cellar mostly closed in summer, and I spaced the tube out from the pipe.

Answered by George on March 19, 2021

Systems typically read around 1" WC. The open hole that is whistling is curious. How far from the exhaust pipe is this hole? With that much air being pulled the WC should be higher than 1/4". WC is the difference in column heights not the reading on the positive scale. Add the below zero value to the above zero value.

Answered by Dawson on March 19, 2021

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP