TransWikia.com

ECU fault codes (OPEL Vectra A 1994 engine 20NE)

Motor Vehicle Maintenance & Repair Asked on December 28, 2020

I have really hard start, bad idling, and sometimes engine goes off gradually in about 5 seconds.
I’ve done the paper clip test with the 10 pin ALDL connector and the error codes are:

code 21 Throttle position sensor_high voltage

code 31 Engine RPM signal (crankshaft sensor)_No signal

code 73 Air flow sensor (AFS)_low voltage

I want to add that, I’ve checked the spark plugs and they’re wet of gas, also i looked inside of the cylinders and they are wet too.
I’ve attached a picture of one the spark plugs, they’re new spark plugs and they even didn’t work for 50 km, but that’s the condition of all of the spark plugs.
When i clean and dry them the engine starts without any pause, but mostly it doesn’t remain the same and it goes off after just 2-3 seconds or it goes to bad idling and then after some time the engine goes off.

Update: all of the fault codes went away after i changed the connectors and connections of the old wires, and the 31 code as @p1ns mentioned was just because i didn’t run the test with the engine running.
So i don’t have any fault codes now, but still abnormal volume of gas injected in the cylinders and i guess that’s the reason of hard start and bad idling. As i mentioned before, with dry spark plugs engine starts less than a second but it usually goes off after just 1-3 seconds and the spark plugs becomes completely wet of gas.

Any advice is really appreciated

All of the spark plugs are in the same condition or worse

One Answer

Code 31 always appears if you do the test not running the engine.

You need to replace the Air Flow meter if code 73 always appears.

Answered by p1ns on December 28, 2020

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP