TransWikia.com

Ways of reducing noise with single coil sound hole pickups

Music: Practice & Theory Asked by pro on December 28, 2020

I currently use an sound hole single-coil magnetic pickup on my acoustic guitar so that I can get both a good “acoustic” guitar sound and so that I can drive electric guitar effects pedals.

In some venues, however, either radio frequency interference (RFI) or noisy AC power sources (light faders in the circuit, for example) cause a lot of noise to be generated either in the pickup cable or the cable itself.

I have a noise-gate pedal that I can use but it can be difficult to tune it so that it doesn’t squelch soft passages, particularly when there’s a lot of signal noise.

What are some other ways of reducing noise with single coil magnetic pickups?

4 Answers

geeks, dorks, scammers, slammers, babyback cramers. -2-4-6-8. This 'blob' has been inactive since 2016. who waits around all day to pee in the soup. thanks for the tips I received though. adios.

Answered by Louism on December 28, 2020

I've got several acoustics with old De'Armond soundhole pickups, which I just love for the vintage tone that they impart to my sound. They produce a hum which varies depending on the environment but I've found an easy way to eliminate the hum is to ground the circuit when needed (which is usually only during recording sessions for me). I just run a wire with an alligator clip from the input jack (strap button) to under the waistband of my jeans. I've also used electrostatic discharge wristbands, the type used during electronics repair but don't like those as much because they get in the way while strumming.

Answered by Barton on December 28, 2020

I've been plagued with noisy singe-coil pickups myself, albeit on a Telecaster. What I ended up doing was to purchase "noiseless" replacement pickups. I'm quite happy with them, though I don't know if you can get them as hole pickups.

I also have a western guitar, but instead of using a hole-pickup, I use a piezo bridge pickup. Those are really cheap and virtually noiseless. You do however, have to do some soldering and drill a hole into the body of your guitar to mount a 1/4 inch female connector.

Unlike using a magnetic pickup, your guitar will still sound like an acoustic guitar when played over the piezo. This may be welcome or undesired, depending on the sound you're trying to achieve.

Answered by Martin Drautzburg on December 28, 2020

This is not always feasible in terms of performance, but the strength of the noise often depends on which way you are facing. If you turn left or right you might find a dip in the volume of the noise (the coils are loop antenna, which are directional).

Electro Harmonix, and maybe others, make a special pedal, the Hum Debugger, that is supposed to identify the hum frequency and cancel it, without adversely affecting other parts of the frequency spectrum. I haven't used it, and from what I hear, different people have different opinions on whether it adversely affects the overall sound or not.

For electric guitars, addressing the shielding of the pickup cavity can help; this involves placing (or fixing) a thin film of metal, that is connected to ground, along the inside of the pickup cavity in order to shield it from external signals. Though I don't know of the feasibility of adding additional shielding to an existing acoustic pickup, I mention this because the design of the pickup, and how (or whether) it incorporates any kind of shielding will affect its sensitivity to noise.

Answered by Dave on December 28, 2020

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP